computing:wyzeshyze
This is an old revision of the document!
- openwrt-mt6000
- Jonathan Haack
- Haack's Networking
- webmaster@haacksnetworking.org
openWRT on two GL.Inet MT6000s
Let's make sure wyze is not leaking … after dropping all 443 853 to DoH and hijacking all udp53 and sending it back to the pihole:
Introduction
tcpdump -ni eth1 udp port 53 and '( host 8.8.8.8 or host 8.8.4.4 or host 1.1.1.1 or host 1.0.0.1 or host 9.9.9.9 )' tcpdump -ni eth1 '(tcp port 443 or tcp port 853 or udp port 853)' and '(host 8.8.8.8 or host 8.8.4.4 or host 1.1.1.1 or host 1.0.0.1 or host 9.9.9.9 )' tcpdump -ni eth1 ip6 and udp port 53 and '( host 2001:4860:4860::8888 or host 2001:4860:4860::8844 or host 2606:4700:4700::1111 or host 2606:4700:4700::1001 or host 2620:fe::fe )' tcpdump -ni eth1 ip6 and '(tcp port 443 or tcp port 853 or udp port 853)' and '( host 2001:4860:4860::8888 or host 2001:4860:4860::8844 or host 2606:4700:4700::1111 or host 2606:4700:4700::1001 or host 2620:fe::fe )'
— oemb1905 2026/09/06 00:56
computing/wyzeshyze.1788656243.txt.gz · Last modified: by oemb1905
Except where otherwise noted, content on this wiki is licensed under the following license: GNU Free Documentation License 1.3
